Tinycontrol the motion sensor

730 ημέρες
Βάρος: 0.20 kg ανά τεμάχιο
002745
2.00 
(2.48  Με ΦΠΑ)
PIR sensor type HC-SR501 allows for motion detection on the basis of infrared radiation. The detector detects the change of 2 separated IR windows and the amplifier converts the signal pulse with a high logic level. Such a signal can easily be used to drive a transistor or logic input processor....
+

PIR sensor type HC-SR501 allows for motion detection on the basis of infrared radiation. The detector detects the change of 2 separated IR windows and the amplifier converts the signal pulse with a high logic level. Such a signal can easily be used to drive a transistor or logic input processor. In the case of the use of Lan Controller detector output must be connected to a logic input INP1-4D. Note, however, that forced the detector Low Low condition is a state of rest, and the high high points to the liberation PIR-a.

On the board there are 2 potentiometers described as Sx i Tx.
Tx-sets the high state after operation of the detector - for several time s potentiometer should be a paragraph. roughly 9 per hour.
Sx-sets the delay vigil after the final liberation - here changes very little adjustment in a short time frame.
The sensor operates in retriggerin, i.e. in the case of motion detection at the output is maintained at all times high.

Tech data:


  • Power supply: 5-24V
  • current consumption: ok 50uA
  • Working range: up to 7m
  • Viewing angle: 360st x100st
  • Signalling: High - motion detection, Low - lack of exercise
  • dimensions: 32x25x27mm 
Part Number:
LANKON-063
Προμηθευτές:
Tinycontrol

Δεν βρέθηκαν δημοσιεύσεις

Γράψτε μια κριτική

Πληροφορίες

Αγόρασαν Επίσης